AVSPARE.COM
parts catalog

CIRCUIT BREAKER 4W9617 - Caterpillar


4W9617 CIRCUIT BREAKER Caterpillar parts 3208, 3304, 3306, 3406, 3406B, 3408, 3512, G3406, G3408
Rating:
51
Alternative (cross code) number:
CA4W9617
4W-9617
4W9617
Caterpillar 4W9617 CIRCUIT BREAKER
Weight: 4 pounds 1 kg.

Buy CIRCUIT BREAKER 4W9617 Caterpillar genuine, new aftermarket tractor parts with delivery
GAS ENGINE, INDUSTRIAL ENGINE,

Compatible equipment models: 4W9617:

GAS ENGINE  G3406   G3408  
GEN SET ENGINE  3208   3304   3306   3406B   3408   3512  
INDUSTRIAL ENGINE  3304   3306   3406   Caterpillar
  For full view, you need register

Information:


Illustration 1 g00737908
Schematic for a typical display power supplyThis diagnostic code is recorded when the main display module reads the voltage of the display power supply circuit and the voltage is above normal. Normal display power supply voltage is 9.0 0.5 DCV. The schematic that is shown above represents a typical installation of the component. Verify the connector contact and wire numbers by using the Electrical System Schematic for the machine that is being serviced.Test Step 1. CHECK THE VOLTAGE AT THE MAIN DISPLAY MODULE.
Use the 7X-1710 Multimeter Probe Group. Check the voltage at the connector for the main display module. Measure the voltage from the contact 34 to the contact 2 (ground).
DO NOT disconnect the harness from the module.
The correct voltage should measure 9.0 0.5 DCV.Expected Result:The voltage that is measured is 9.0 0.5 DCV.Results:
OK - The voltage is 9.0 0.5 DCV. The display power supply voltage is correct. Check the main display module for the same diagnostic code. If the service code indicator is still ON, the main display module has failed.Repair: It is unlikely that the main display module has failed. Exit this procedure and perform this procedure again. Also, recheck if the diagnostic code indicator is illuminated for this diagnostic code. If the cause of the diagnostic code is not found, replace the main display module. See Testing and Adjusting, "Module - Replace".STOP
NOT OK - The voltage is NOT 9.0 0.5 DCV. The display power supply voltage is NOT correct. Proceed to test step 2.Test Step 2. CHECK FOR A SHORT TO +BATTERY
Disconnect the machine harness from the main display module.
At the machine harness connector for the main display module, measure the voltage from the connector contact 34 to 2 (ground).Expected Result:The voltage that is measured is 0.0 0.5 DCV.Results:
OK - The voltage is 0.0 0.5 DCV. The voltage is correct. The main display module has failed.Repair: It is unlikely that the main display module has failed. Exit this procedure and perform this procedure again. Also, recheck if the diagnostic code indicator is illuminated for this diagnostic code. If the cause of the diagnostic code is not found, replace the main display module. See Testing and Adjusting, "Module - Replace".STOP
NOT OK - The voltage is NOT 0.0 0.5 DCV. The harness has failed.Repair: Repair the harness or replace the harness.STOP

Caterpillar parts catalog:

Caterpillar parts catalog
3306 Generator Set 85Z00001-03763
G3408 Engine 6NB00001-UP
3408B Generator Set 78Z01144-04866
3306 Generator Set Engine 5DA04351-UP
G3406 Industrial Engine Natural Gas 4FD00001-UP
3208 Generator Set Engine 5YF00001-UP
3406B Generator Set 4RG00001-01501
3406 Industrial Engine 90U19731-UP
G3406 Engine 1RK00001-UP
3306 Industrial Engine 66D49919-UP
3306 Generator Set 85Z03764-UP
3208 Generator Set Engine 30A05100-UP
3304B Generator Set 83Z03096-UP
3304 Industrial Engine 04B26769-UP
G3306 ENGINE 07Y04279-UP
3512 Generator Set Engine 67Z00772-UP
3406C Generator Set 2WB11476-UP
3408C Generator Set 78Z04867-UP
3406C Generator Set Engine 4RG01502-UP


Parts circuit Caterpillar catalog:

6T3645 CIRCUIT BREAKER GP
130G, 3116, 3126B, 315B, 315B FM L, 315B L, 317B LN, 318B, 3208, 3304, 3304B, 3306, 3306B, 3406B, 3406C, 3406E, 3408, 3408B, 3408C, 3412, 3412C, 3412E, 3456, 3508, 3508B, 3512, 3512B, 3512C, 3516, 351...
6T3644 CIRCUIT BREAKER AS
120H, 120M, 12H, 12H NA, 12M, 135H, 140G, 140H, 140H NA, 140M, 143H, 14H, 14M, 160H, 160M, 163H, 16H, 16M, 2290, 2390, 2391, 2491, 24M, 2590, 30/30, 3114, 3116, 3126, 3208, 320B, 3304, 3304B, 3306, 33...
6T3642 CIRCUIT BREAKER AS
12H, 140H, 160H, 30/30, 3114, 3116, 3126, 3208, 3304, 3304B, 3306, 3306B, 3406, 3406B, 3406C, 3408, 3408C, 3412, 3412C, 3412D, 3508, 3508C, 3512, 3512C, 3516, 3516B, 3606, 3608, 3612, 3616, 5130B, 523...
6T3643 CIRCUIT BREAKER AS
120H, 12H, 135H, 140H, 143H, 14H, 160H, 163H, 16H, 24H, 30/30, 3116, 3126, 3126B, 3176C, 3196, 3208, 320D, 320D FM, 324D FM, 324D FM LL, 325D FM, 325D FM LL, 3304, 3304B, 3306, 3306B, 3406E, 3408B, 34...
1394724 CIRCUIT BREAKER AS
120M 2, 12M 2, 140M 2, 160M 2, 2290, 2390, 2391, 2491, 24H, 2590, 315B, 315B FM L, 315B L, 317B LN, 318B, 345B L, 365B, 365B II, 365B L, 385B, 5090B, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 551, 5...
7W0167 CIRCUIT BREAKER
3208, 3304, 3306, 3406, 3406B, G3406
5N3350 CIRCUIT BREAKER--250 AMPERES
3304, 3306, 3408, 3512, G3406, G3408
4P3843 CIRCUIT BREAKER AS
3406B, 3408, 3412, 3508, 3512, 3516, G3508, G3512, G3516, SR4
4P3842 CIRCUIT BREAKER AS
3406B, 3408, 3412, 3508, 3512, 3516, G3508, G3512, G3516, SR4
3N5582 CIRCUIT BREAKER
3304, 3306, 3406, 3408, 3412, G3408, SR4
4W9614 CIRCUIT BREAKER
3304, 3306, 3408, 3512, G3406, G3408
4W9618 CIRCUIT BREAKER
3208, 3304, 3306, 3406, 3406B, 3408, 3512, G3406, G3408
7W0168 CIRCUIT BREAKER
3208, 3304, 3306, 3406, 3406B, G3406
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.