CIRCUIT BREAKER 7W0167 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8T-0292 Bolt 2
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Note: Put identification marks on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and tube assemblies. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the coolant from the cooling system into a suitable container for storage or disposal.
Illustration 1 g00508835
Illustration 2 g00508837
Remove bolts (2). Remove exhaust elbow (1) and exhaust pipe assembly (3).
Illustration 3 g00746355
Loosen clamp (4).
Disconnect coupling (5).
Illustration 4 g00746356
Loosen clamps (6) and (7).
Remove two top bolts (8) and install Tooling (A). Remove remaining bolts (8). Remove aftercooler (10).
Remove gasket (9) from aftercooler (10).