CIRCUIT BREAKER AS 9S0174 - Caterpillar

Illustration 1 g00824832
Optional control panel
(1) Display for the MIDS
(2) Keypad for the MIDS
(3) "EMERGENCY STOP" button
(4) "ENGINE ON" indicator
(5) "ACTIVE ALARM" indicator
(6) "ENGINE FAILURE" indicator
(7) "MANUAL PRELUBE" switch and "PRELUBE ACTIVE" indicator
(8) Engine control switch
(9) "DESIRED SPEED" potentiometer The features of the control panel are described below.MIDS
The Machine Information Display System (MIDS) is a device which enables the operator to monitor engine operation. The MIDS receives information from the ECM. The device cannot be used for programming. A screen display and a keypad provide the interface for the operator.The keypad is protected in a sealed membrane. When you press a key, press firmly. When a key is pressed sufficiently, a small red indicator in the upper left corner of the keypad will flash once.When the control panel is powered up, the screen becomes active. To view the options for the display, press the "?" key. Table 1 lists the menu.
Table 1
Menu
(1) Status Information
(2) Detonation Levels
(3) Ignition Timing
(4) Filtered Burn Times
(5) Unfiltered Burn Times
(6) Exhaust Temperatures
(7) Turbo Temperatures
(8) Events and Diagnostics
(9) Display Setup To select an option, press the number on the keypad that corresponds to the selection. To exit the option, press the "?" key or any of the numbered keys. It is not necessary to return to the menu in order to select a different option. When you press a different numbered key, the corresponding option is displayed."EMERGENCY STOP" Button
Only use the "Emergency Stop" button in order to stop the engine in an emergency situation. Do not use the "Emergency Stop" button for normal engine stopping.To prevent damage to the engine, use the mode control switch or use the remote start/stop initiate contact for normal engine stopping.
The fuel and the ignition are immediately shut off when the "EMERGENCY STOP" button is pressed. No postlube cycle occurs.The "EMERGENCY STOP" button and the engine control switch must be reset before the engine will start. To reset the "EMERGENCY STOP" button, turn the button clockwise. To reset the engine control switch, turn the switch to the OFF/RESET position. Note: More than one "EMERGENCY STOP" button may be available for use.Indicators
The remote panel has three indicators for the status of the engine operation.Illumination of the green "ENGINE ON" indicator indicates normal operation.The yellow "ACTIVE ALARM" indicator illuminates if the control system initiates a warning for an event or a diagnostic condition.The red "ENGINE FAILURE" indicator illuminates if the control system shuts down the engine due to an event or a diagnostic condition. The "ENGINE FAILURE" indicator also illuminates if an emergency stop is performed."MANUAL PRELUBE" Switch and "PRELUBE ACTIVE" Indicator
The control for the prelube is not used. Engine Control Switch
The engine control switch has four positions: "AUTO", "START", "STOP" and "OFF/RESET""AUTO"