CLAMP,WIRE TIE 1873960C1 - Caterpillar

(1) Rubber toric seals and all surfaces in contact with them must be clean and dry at assembly. Put a thin layer of oil on the contacting surfaces of the metal seals just before installation.(2) Torque for bolt ... 2440 270 N m (1800 200 lb.ft.)(4) Thickness of shims (3) to be 0.05 mm (.002 in.) less than the distance measured between the end of the sprocket shaft and the face of the sprocket hub.(5) Put 7M7456 Bearing Mount on the outside diameter of retainer.(6) Install sprocket on shaft with a force of ... 534 000 to 578 000 N (120,000 to 130,000 lb.) Measured distance (4) between the end of the shaft and the face of the retainer must be ... 2.3 1.5 mm (.09 .06 in.) If measurement is 0.00 mm (0.00 in.) the sprocket is not installed correct.(7) (14) End play of bearings ... 0.00 to 0.08 mm (.000 to .003 in.) loose. Use shims (13) for adjustment.(8) Measure distance from face on housing to top of rack. Distance must be ... 52.8 2.5 mm (2.08 .10 in.)(9) Put 7M7260 Liquid Gasket on contacting surfaces of case, cover and disconnect housing at time of assembly.(10) End play of bearings ... 0.00 to 0.08 mm (.000 to .003 in.) loose. Use shims (17) for adjustment.(11) Get the machine on a level surface and fill case to bottom of plug.(12) Rolling torque check. With all parts assembled, torque needed to turn output shaft is ... 39 to 62 N m (29 to 46 lb.ft.)(15) End play of bearings ... 0.00 to 0.08 mm (.000 to .003 in.) loose. Use shims (16) for adjustment.(18) Put 9M3710 Anti-seize Compound on splines of shaft.(19) Torque for bolts (two) ... 135 14 N m (100 10 lb.ft.) Torque for bolts marked X (ten) ... 475 50 N m (350 35 lb.ft.)