CLAMP 1W1490 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    
B     1P-2420     Transmission Repair Stand     1    
C     1P-1861     Retaining Ring Pliers     1    
D     1P-1863     Retaining Ring Pliers     1    
E     4C-9614     Silicone Sealant     1    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01300229
Raise the temperature of bearing (11). Install bearing (11) onto shaft assembly (9). Use Tooling (D) in order to install retaining (10) .
Illustration 2 g01300228
Install shaft assembly (9). Use Tooling (C) in order to install retaining (8).
Illustration 3 g01357848
Apply Tooling (E) in the area at the joint of the torque converter housing and the transmission housing. Position the gasket and oil pan (6). Install bolts (5) to a torque of 55 10 N m (40 7 lb ft).
Connect harness assembly (7) .
Illustration 4 g01300224
Install screen (4), magnetic filter (3), cover (2), and bolts (1) .
Illustration 5 g01300222
Attach Tooling (A) and a suitable lifting device to the transmission. The weight of the transmission is approximately 680 kg (1500 lb). Remove the transmission from Tooling (B) .