CLAMP AS-TURBINE 1W9311 - Caterpillar

How To Log On
Overview
You can use either a local (serial) connection, or a remote (Telnet or SSH) connection with a computer on the same network as the Network Management Card to access the "Command Line Interface".Use case-sensitive user name and password entries to log on (by default, cat and cat for an Administrator, or device and cat for a Device User). A Read-Only User cannot access the "Command Line Interface".ReferenceIf you cannot remember your user name or password, see the "How to Recover from a Lost Password" section in the, "General Information" chapter of this manual.Remote Access To The Command Line Interface
You can access the "Command Line Interface" through Telnet or SSH. Telnet is enabled by default. Enabling SSH disables Telnet.To enable or disable these access methods, use the "Web interface". On the "Administration" tab, select "Network" on the top menu bar, and then the access "option" under "Console" on the left navigation menu.Telnet For Basic Access
Telnet provides the basic security of authentication by user name and password, but not the high-security benefits of encryption. To use Telnet, to access the "Command Line Interface":
From a computer that has access to network on which the Management Card is installed, at a command prompt, type "telnet", and the IP address for the Management Card (for example, telnet 139.225.6.133, when the Management Card uses the default Telnet port of 23), and press "ENTER". If the Management Card uses a non-default port number (from 5000 to 32768), include a colon or a space, depending on your Telnet client, between the IP address (or DNS name) and the port number. These are commands for general usage: some clients do not allow you to specify the port as an argument and some types of Linux might want extra commands.
Enter the user name and password (by default, cat and cat for an Administrator, or device and cat for a Device User).Ssh for High-Security Access
If you use the high security of SSL for the "Web interface", use SSH for access to the "Command Line Interface". SSH encrypts user names, passwords, and transmitted data. The interface, user accounts, and user access rights are the same whether you access the "Command Line Interface" through SSH or Telnet. To use SSH configure SSH and have an SSH client program installed on your computer first.Local Access to the "Command Line Interface"
For local access, use a computer that connects to the Management Card through the serial port to access the "Command Line Interface":
Select a serial port at the computer and disable any service that uses the port.
Connect the provided serial cable from the selected port on the computer to the configuration port at the Management Card.
Run a terminal program, and configure the selected port for 9600 bps, eight data bits, no parity, one stop bit, and no flow control.
Press "ENTER" twice. At the prompts, enter your user name and password.Main Screen
Following is an example of the screen displayed when you log on to the "Command Line Interface" at the Management Card.
Illustration