CLAMP 3009283 - Caterpillar

Introduction
This Special Instruction covers the installation procedure for the 290-9517 Machine Control and Mounting Gp .Safety Section
Illustration 1 g00104545
Attach a "Do Not Operate" warning tag or a similar warning tag to the start switch or to the controls before you service the equipment. These warning tags Special Instruction, SEHS7332 are available from the Cat dealer.Required Parts
Table 1
290-9517 Machine Control and Mounting Gp Revision -02    
Item    Qty    Part No    Description    
(1)     1     171-2584     Bracket As    
(2)     1     366-8821     Electronic Control Module    
(3)     2     7X-2536     Bolt    
(4)     2     7X-2538     Bolt    
(5)     4     8T-4224     Hard Washer    
(6)     4     9X-2480     Bolt    
(7)     4     9X-8256     Washer    
Illustration 2 g02193775
Installation Procedure
Illustration 3 g02196274
(1) 171-2584 Bracket As (2) 366-8821 Electronic Control Module (3) 7X-2536 Bolt (4) 7X-2538 Bolt (5) 8T-4224 Hard Washer (6) 9X-2480 Bolt (7) 9X-8256 Washer
Illustration 4 g02196296
(2) 366-8821 Electronic Control Module (6) 9X-2480 Bolt (7) 9X-8256 Washer
Install bracket assembly (1) below the existing controller. Use bolts (4) and washers (5) to secure the top portion of the bracket. Use bolts (3) and washers (5) to secure the bottom portion of the bracket.
Attach controller (2) to bracket (1). Secure the controller with bolts (6) and washers (7) .Note: Electronic Control Module (2) is shipped with no software installed. Software file "3668671" must be downloaded from SISweb and installed on Electronic Control Module (2) prior to using auxiliary hydraulics.