CLAMP-SPRING 4738115 - Caterpillar

Illustration 70 g00776247
Route the wire harness for 198-1402 Monitor Keypad Module (RH) (28) to 194-6619 Control Unit Box (KU) .
Illustration 71 g00776312
Remove cover (31) underneath the stick assembly.
Illustration 72 g00776329
Loosen clamp (32) .
Tie the new 196-1189 Wiring Harness to the existing wire harness (33) .
Illustration 73 g00777159
196-1189 Wiring Harness
Remove the 40-pin connector from the 196-1189 Wiring Harness . Install one 155-2255 Connecting Plug Kit .
Illustration 74 g00777149
Pull the wire harnesses through the hoses that protect the wire harnesses. Route 196-1189 Wiring Harness (33) over the boom assembly and underneath the cab.
Illustration 75 g00777171
Install 197-5016 Hydraulic Electronic Control Harness (34). Tie 197-5016 Hydraulic Electronic Control Harness (34) to the existing wire harness. Pull the wire harnesses through the hose.
Connect 197-5016 Hydraulic Electronic Control Harness (34) to 196-1189 Wiring Harness (33) .
Remove the existing plugs from the following wire harnesses. Only remove the plugs that connect to the solenoids of the main control valve.
197-0519 Wiring Harness (Right Hand and Left Hand Feed Roller Motor)
197-0520 Wiring Harness (Delimbing Knife Open/Close)
197-0521 Wiring Harness (Holding Arm Open/Close)
197-0522 Wiring Harness (Cut System On/Off)
197-0523 Wiring Harness (Roller Arm Open/Close)
197-0524 Wiring Harness (Tilt Up/Down)
Install the existing 183-5758 Plugs that were removed from the 156-4606 Wiring Harness .
Install the wire harnesses to the main control valve. See Illustration 53.
When possible, use the existing wires for the sensors. Simply install 183-5757 Plugs onto the ends of the wires in order to connect the wires to the 194-6617 Control Unit Box (Analog Input). See Illustration 53.
Install the remaining wire harnesses. Route the wires according to Illustration 53.
Illustration 76 g00777640
Install 196-1107 Cover As (37) with two 8T-4224 Hard Washers (35) and two 5A-3604 Bolts (36) .
Illustration 77 g00777643
Cut 8 mm (0.32 inch) from the top edge of 189-0585 Cover As (38) .
Illustration 78 g00777741
Illustration 79 g00777743
Fit 189-0585 Cover As (38) onto the left side of the frame. If the left side of the cover does not completely cover the control boxes, weld a piece of round steel (40) to the cover.
Install 189-0585 Cover As (38) with three 6V-8202 Bolts (39) .
Install the valve cover onto the harvester head.