CLAMP 4D6696 - Caterpillar

4D6696 CLAMP Caterpillar parts 633C, 641B, 657B, 666, 768B, 769

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4D6696
4D-6696
4D6696

Weight: 0.40 pounds 0 kg.

Information:

CENTERLINE OF BOLT TO BOLT/CLIP 45.974 mm

MOUNTING ONE END

MOUNTING BOLT SIZE 0000010.3120

THICKNESS 4.775 mm

TUBE OFFSET ABOVE CENTER

TUBE RADIUS 25.4 mm

VINYL COATED N

WIDTH 38.1 mm

Buy CLAMP 4D6696 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACTOR, WHEEL TRACTOR,

Compatible equipment models: 4D6696:

TRACTOR 768B

TRUCK 769

WHEEL TRACTOR 633C 641B 657B 666 Caterpillar

Number on catalog scheme: 9

For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A(1) 9U-6198 Crankshaft Turning Tool 1
A(2) 9U-7336 Housing 1
5P-7305 Engine Turning Tool 1
B 367-8608 Engine Timing Pin 1
C 364-9107 Fuel Pump Locking Pin 1
D 370-8376 Cap Kit 1
(1) The Crankshaft Turning Tool is used on the front pulley.
(2) This Tool is used in the aperture for the electric starting motor.Start By:
If necessary, remove the fuel filter base. Refer to Disassembly and Assembly, "Fuel Filter Base - Remove and Install" for the correct procedure .
If necessary, remove the fuel priming pump. Refer to Disassembly and Assembly, "Fuel Priming Pump - Remove" for the correct procedure. Note: Either Tooling (A) can be used. Use the Tooling that is most suitable.
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorized personnel that have the correct training.Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information. Refer to System Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Turn the fuel supply to the OFF position.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g01967536
Use Tooling (A) in order to rotate the crankshaft so that number one piston is at top dead center position . Refer to System Operation, Testing and Adjusting, "Fuel Injection Timing - Check". Use Tooling (B) in order to lock the crankshaft so that number one piston is at top dead center position.
Remove plug (8) and remove O-ring seal (9) (not shown). Use Tooling (C) in order to lock