CLAMP 5062221 - Caterpillar

Installation Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Illustration 1 g00911012
Position gear motor (10). Install bolts (9). Install connectors (8) .
Illustration 2 g00911043
Install adapter (7) .
Illustration 3 g00911009
Install fan (6). Install bolts (5). Tighten the center bolt to a torque of 30 7 N m (22 5 lb ft).
Illustration 4 g01028984
Position fan drive assembly (4). Install bolts (2). Tighten bolts (2) to a torque of 30 7 N m (22 5 lb ft). Connect hose assemblies (3). Connect tube assemblies (1) .
Check the hydraulic oil level. If the hydraulic oil level is low, add hydraulic oil to the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".