CLAMP AS 5119290 - Caterpillar

Removal Procedure
Table 1
Tool Part Number Part Description Qty
A 8T-9011 Component Cleaner 1
B 4C-9500 Quick Cure Primer 1
C − Loctite 17430 1 Start By:
Remove the crankshaft front seal.
Remove the camshaft.
Illustration 1 g01360127
Remove bolts (1) and remove engine mount (2).
Illustration 2 g02149190
Remove bolts (3) and bolts (4). Remove bolts (5) that connect the front of the oil pan to the front housing.
Illustration 3 g01360155
Remove front housing (6). Installation Procedure
Install front housing (6) in the reverse order of removal.
Illustration 4 g01351898
Clean the joint face on front housing (6) with Tooling (A).
Apply Tooling (B) to the joint face. Allow the primer to dry for at least 3 to 5 minutes.
Apply Tooling (C) in a bead with a width of 3.0 0.5 mm (0.12 0.02 inch) to the joint face. Refer to Illustration 4. Spread the sealant uniformly. Front housing (6) must be installed within 10 minutes of applying the sealant.