CLAMP AS 5164011 - Caterpillar

Tightening torques for threaded connections
General requirements in Nm:
Nm ÷ 9.81(10) = kpmNm ÷ 1.3558 = lb.ft Tightening torques in Nm
Repair data
Camshafts (injection pump drive and valve gear)
Camshaft bearing journal diameters
Internal diameter of bearing bore in crankcase
Balancing weights
Bearing point diameters - two- and three-cylinder engines
Bearing point diameters - four-cylinder engines
Piston rings .L30. H.L 30 Piston rings .L 31, .M 31, .L 40, .M 40, .L 41, .M 41, Fuel injection equipment
Up to engine serial numbers: 2 L 40.16. 3 - 4 L 40.15. .M 40.12. L 30 and H.L 30 From engine serial No.: 2 L 40.17. 3 - 4 L 40.16. M 40.13. L 31. M 31. L 41. M 41 Injectors Governors
L 30. H .L30 L 40. M 40 with injection pumps PFR 1K 80A 477 L 31. M 31. L 40. M 40 with injection pump PFR 1K 90A 498 and L 41 and M 41 Lubricating oil content and dipstick
The lubricating oil contents stated here are to be understood as approximate; they apply to engines with a lubricating oil cooler and refer to oil changes including renewal of the lubricating oil filter. In certain cases engines of versions "S" and "Z" are not equipped with an oil cooler. In this case the oil content is reduced by app. 0.2 - 0.5 litre.In all cases fill to the "Max" mark on the dipstick.Key to circuit diagrams (DIN 40719)
HATZ - Wiring identification
Circuit diagram 12 V - system with fault display Circuit diagram 12 V - system with fault display and starter protection module Circuit diagram 12 V - system with automat. shut down and starter protection module Circuit diagram 12 V - system with automatic shut-down and time relay Circuit diagram 12 V - automatic start/stop with repeat start interlock and time relay Circuit diagram 24 V - system with fault display Circuit diagram 24 V - system with fault display and starter protection module Circuit diagram 24 V - system with automatic shut-down and starter protection module Circuit diagram 24 V - system with automatic shut-down and time relay Circuit diagram 24 V - automatic start/stop with repeat start interlock and time relay Trouble-shooting table for electrical system
Trouble-shooting at instrument box Trouble-shooting at the battery Trouble-shooting at the starting device Trouble-shooting at the pre-heat system Trouble-shooting at the alternator Trouble-shooting at engine monitor and display Trouble-shooting at electromagnetic components