CLAMP 5M5689 - Caterpillar

System Operation Description:Use this procedure to troubleshoot any suspect problems with the following indicator lamps:
Low oil pressure lamp
High coolant temperature lamp
Low coolant level lamp
Maintenance indicator lamp
Warning lamp
Diagnostic lampThe indicator lamps are activated by the Electronic Control Module (ECM) in order to inform the operator of various engine conditions. When the keyswitch is placed in the ON position, the diagnostic lamp and the warning lamp is illuminated by the ECM for a brief period. The ECM provides a high side driver for all of the lamp outputs. The most likely cause of a problem with an indicator lamp is the bulb. The next most likely cause is a problem with a wire or with a connector. The least cause is a problem with the ECM.Note: An override feature is available in Caterpillar Electronic Technician (ET) for each of the lamp circuits. The override can be used to troubleshoot the lamp circuits.
Illustration 1 g01367132
Schematic for the engine's lamp circuits
Note: There are configuration parameters that are associated with the low coolant level lamp and the maintenance indicator lamp. Ensure that these parameters are configured correctly prior to troubleshooting the lamp circuits. Refer to Troubleshooting, "Configuration Parameters" for information that is related to the configuration of the lamp circuits.Test Step 1. Inspect the Electrical Connectors and the Wiring
Remove electrical power from the ECM.
Illustration 2 g01367265
Locations of the connectors that are associated with the lamp circuits (typical left rear engine view)
(1) Engine interface connectors
(2) J2/P2 ECM connectors
(3) J1/P1 ECM connectors
Thoroughly inspect connectors (1), (2), and (3). Also, thoroughly inspect any of the other connectors that are associated with the lamp circuits. Refer to the Schematic of the engine for connector locations. Refer to Troubleshooting, "Electrical Connectors - Inspect".
Illustration 3 g01367230
Terminal locations at the P1 ECM connector that are for the lamp circuits
(P1-19) Diagnostic lamp
(P1-20) Warning lamp
(P1-28) Low oil pressure lamp
(P1-29) High coolant temperature lamp
(P1-30) Low coolant level lamp
Illustration 4 g01367240
Terminal locations at the P2 ECM connector that are for the lamp circuits
(P2-6) Maintenance indicator lamp
Illustration 5 g01367257
Terminal locations at the engine interface connector that are for the lamp circuits
(Terminal 20) Low coolant level lamp
(Terminal 21) High coolant temperature lamp
(Terminal 22) Maintenance indicator lamp
(Terminal 23) Low oil pressure lamp
(Terminal 24) Diagnostic lamp
(Terminal 25) Warning lamp
Perform a 45 N (10 lb) pull test on each of the wires for the lamp circuits.
Check the torque of the allen head screw on the ECM connectors and the engine interface connectors. Refer to Troubleshooting, "Electrical Connectors - Inspect" for the correct torque values.
Check the harness and the wiring for abrasion and for pinch points from the dash display back to the ECM. Expected Result:All of the connectors, pins and sockets are completely coupled and/or inserted and the harness and wiring are free of corrosion, of abrasion and of pinch points.Results:
OK - The harness and connectors appear to be in good repair. Proceed to Test Step 2.
Not OK - The connectors and/or wiring need repair.Repair: Repair the wiring and/or the connectors. Replace parts, if necessary. Ensure that all of the seals are properly in