CLEVIS 0657289 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A         Loctite 7649 Primer N     1    
B         Loctite 545     1    
C     5P-0960     Grease Cartridge (MOLYBDENUM)     1    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Lubricate the internal components with the lubricant that is being sealed.
Illustration 1 g01097193
Apply Tooling (A) and then apply Tooling (B) to the threads of plug (12) and plug (13) prior to installation.
Install plug (12) and plug (13) to sleeve (6) . Tighten the two plugs to a torque of 20 N m (15 lb ft).
Illustration 2 g01097185
Install wiper seal (10) . Install the seal with the sealing lip facing away from sleeve (6) .
Install cup seal (9) . Install the seal with the sealing lip facing towards the inside of sleeve (6) .
Install seal assembly (8) to sleeve (6) .
Install seal assembly (5) and wear ring (7) to piston (11) .
Install piston (11) to sleeve (6) .
Install spring (3) to piston (11) .
Apply Tooling (C) to O-ring seal (4) prior to installation. Install O-ring seal (4) to cap (2) .
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install cap (2) . Install two bolts (1) evenly. Tighten the two bolts to a torque of 47 9 N m (35 7 lb ft).End By: Install the brake release cylinder. Refer to Disassembly and Assembly, "Brake Release Cylinder - Install".