CLEVIS AS 2775542 - Caterpillar

"For Parts Stock Only"
The 145-0145 Monitor Electronic Control Module or 164-5766 Monitor Electronic Control Module can be changed into a 188-2928 Monitor Electronic Control Module if you remove the corresponding Display EPROM Control:
145-0141 Display EPROM Control
164-5764 Display EPROM Control You must install the new 171-2087 Display EPROM Control (Cat ID-English/Spanish).The 164-5767 Monitor Electronic Control Module or 171-2090 Monitor Electronic Control Module can be changed into a 187-1599 Monitor Electronic Control Module if you remove the corresponding Display EPROM Control:
164-5765 Display EPROM Control
171-2088 Display EPROM Control You must install the new 187-1600 Display EPROM Control (Cat ID-English/German).Procedure 1
If your machine only requires the new flash file, this is the procedure to program the ECM and the procedure to update the "Fuel Rate Scaling".
Note: When you flash the new software, the screen of the CAT ID will display "Application Not Recognized". This condition is normal.
Use Electronic Technician, JERD2124 Version 3.0 or higher in order to flash the ECM of the engine with the appropriate software for the machine model. A 7X-1700 Communication Adapter and proper connecting cables are required. Additional service information can be found in the references that are listed.Note: Because of the errors with the original software of the ECM, all the parameters of the machine that are related to the fuel consumption may not be accurate. Complete the following steps in order to eliminate errors or minimize the errors.
Obtain the passwords from the factory in order to reprogram the value for "Lifetime Fuel Consumption". You will need to provide the following information:
"Service Tool Serial Number"
"Engine Serial Number"
"ECM Serial Number"
"Total Tattletale Count"
"Reason Code"
Determine if the "Fuel Rate Scaling" for the ECM has been programmed by checking the tattletale for the "Fuel Rate Scaling" on the configuration screen.
If the "Fuel Rate Scaling" has been programmed, reset the factor to "0". Reset the value of the "Total Fuel" that is consumed to 0.67 (67%) of the existing number. You also need to reset the value of the "Total Max Fuel" to .67 (67 %) of the existing number. This will require the previously obtained factory passwords. All parameters of output in the future that are related to the fuel consumption will be accurate. This does not include "Lifetime Totals". The "Lifetime Totals" that is related to fuel consumption will not be accurate. The "Lifetime Accuracy" will improve as more of the fuel is consumed by the engine of the machine.Note: If the electronic display module of the CAT ID is installed in the cab of the machine at a later time, the following information from the ECM will need to be reset: "Rolling Totals", "Last Field Totals" and "Current Field Totals". In order to reset the values, use the input keys of the display. Refer to Special Instruction, REHS0193, "Caterpillar Information Display".Note: You must reset the corresponding parameters of software if you cannot reset the values of the following parameters at the screen of the CAT ID: "Rolling Totals" and "Field Totals". Use the Electronic Technician. Go to the "Configuration/Service