CLIP BUS 0907249 - Caterpillar

ACTION REQUIRED
Replace the existing 383-5648 Support Pin with an improved 440-5585 Support Pin. Refer to the attached Rework Procedure.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-10000 hrs,
0-72 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 1.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
1. Remove the fixing plate by removing two screws. Retain the screws for later reuse.
2. Remove the seat cushion by sliding the seat cushion forward and pressing downward.
Image1.1.1
Image1.1.2
3. Turn over the seat cushion.
4. Pull out the existing 383-5648 Support Pin from slide lever and remove the slide lever.
Image1.2.1
5. Install a new 440-5585 Support Pin.
6. Insert the new 440-5584 Slide Lever to the new 440-5585 Support Pin.
7. Inlay the 332-0195 Clip to groove of 440-5585 Support Pin.
8. Install the new spring to projection on the slide lever.
8. Set the protruding portion of slide lever into the hole of support.
Image1.3.1
Image1.3.2
Image1.3.3
Image1.3.4
9. Install the protruding portions of the seat cushion into the groove of the seat frame.
10. Slide the seat cushion backward by pressing downward.
11. Install the fixing plate by using the two screws that were removed and retained.
Image1.4.1
Image1.4.2
Image1.4.3