CLIP 1171287 - Caterpillar

Machine Swings (5)This warning label is located on the left rear and right rear of the upper structure.
g01067376
Machine swings. Stay back. Crushing hazard could cause serious injury or death.
High Pressure Gas (6)This warning label is positioned on the accumulator.
g01442488
This system contains high pressure gas. Failure to follow the instructions and warnings could cause an explosion, resulting in possible injury or death.Do not expose to fire. Do not weld. Do not drill. Relieve pressure before discharging.See Operation and Maintenance Manual for charging and discharging. See your Caterpillar Dealer for tools and detailed information.
Rotating Fan (7)This warning is located on the hydraulic oil cooler in the range of the handle.
g01442489
Rotating fan blades can result in personal injury or death.Stop the engine and allow the fan to come to a complete stop before making any test or adjustment.Before starting the engine, make sure all of the finger guards are installed and the guard door is closed. Do not allow any tools or test equipment to protrude or vibrate into the path of the rotating fan blades.
Hot Radiator (8)This warning is located on the coolant reservoir which is adjacent to the supply tube.
g01442490
The coolant is hot and the coolant is under pressure. Do not touch the hot surfaces. Refer to the Operation and Maintenance Manual for the procedure to follow when you check the radiator.
Product Link (9) If equipped, this warning label is located in the cab.
g01370917
This machine is equipped with a Caterpillar Product Link communication device which must be deactivated within 12 m (40 ft) of a blast zone. Failure to do so could result in serious injury or death.
Improper Connections for Jump Start Cables (10)This warning is located on the battery box.
g01067366
IMPROPER JUMPER CABLE CONNECTIONS CAN CAUSE EXPLOSION RESULTING IN PERSONAL INJURY.BATTERIES MAY BE LOCATED IN SEPARATE COMPARTMENTS. WHEN USING JUMPER CABLES, ALWAYS CONNECT POSITIVE (+) CABLE TO POSITIVE (+) TERMINAL OF BATTERY CONNECTED TO STARTER SOLENOID AND NEGATIVE (-) CABLE FROM EXTERNAL SOURCE TO STARTER NEGATIVE (-) TERMINAL (IF MACHINE NOT EQUIPPED WITH STARTER NEGATIVE TERMINAL, CONNECT TO ENGINE BLOCK.) FOLLOW PROCEDURE IN THE OPERATION MANUAL.
Do Not Spray Ether (11)This warning is located on the engine inlet manifold and on the air cleaner.
g01442492
If equipped with an air inlet heater (AIH) for cold weather starting, do not use aerosal types of starting aids such as ether. Such use could result in an explosion and personal injury.