CLIP 1629992 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
2 6V5839 WASHER-HARD
2 6V7732 BOLT-LOCKING
2 6V7744 LOCKNUT
2 8T0722 BOLT-HEX HEAD
1 1023482 GASKET
1 2662973 CLAMP-'U'
1 4609059 BRACKET
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 11% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Before Failure:
Inspect and install a new support bracket.
When performing a scheduled oil change, while the tank is empty, remove the access panel and inspect for broken diffuser tube. Refer to Image1. If not broken, install the bracket and clamp per the After Failure instruction below.
After Failure:
If the inspection reveals a broken tube, prepare and weld a sleeve on the broken end of diffuser tube, install the bracket and a clamp, use it to locate and weld the sleeved diffuser tube to the block in the tank wall.
Image1
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-36000 hrs,
0-48 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 2.0-hour job
Note: 2.0 hours is allowed for inspection and installation of bracket and clamp.
Note: An additional 3.0 hour is allowed if the diffuser is found broken and needs repair.
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
Durring a scheduled oil change, check for broken diffuser. If broken, prep and weld a sleeve on diffuser tube. Weld sleeve to block using the bracket and clamp to help locate the tube.
If not broken, just add the bracket and clamp.
Image1.1.1
Image1.1.2
Image1.1.3