CLIP 1N5166 - Caterpillar

1. Remove the bolt and retainer that hold the brake drum to the brake shaft. Remove brake drum (1).2. Disconnect the brake linkage. 3. Remove the four bolts that hold plate (4) to the bearing cage. Remove the plate and brake linings (2). Remove lever (3).4. Remove the three springs that hold the brake linings to the plate. Remove the brake linings.Assemble Swing Brake
1. Put the brake linings in position on the plate. Install the three springs that hold the brake linings to the plate. 2. Install lever (3). Put plate (4) and brake linings (1) in position on the bearing cage. Install four bolts (2) that hold the plate to the bearing cage. 3. Connect brake linkage (7).4. Install brake drum (8) on the brake shaft. The spline on the brake shaft and brake drum must be clean and dry at assembly.5. Install retainer (6) and bolt (5). Tighten the bolt to a torque of 200 20 lb.ft. (27.7 2.8 mkg).