CLIP - RETAINING 2U2752 - Caterpillar

Crushing Hazard (8)
Illustration 7 g01371647
This safety message is located on the left-hand side of the machine near the articulation joint.
Connect the steering frame lock between the front and the rear frames before lifting, transporting, or servicing the machine in the articulation area. Disconnect the steering frame lock and secure the steering frame lock before resuming operation. Severe injury or death could occur.
No Clearance (9)
Illustration 8 g01371644
This safety message is located on both sides of the machine near the articulation joint.
Stay back a safe distance. No clearance for a person in this area when the machine turns. Severe injury or death from crushing could occur.
Bottom Guard (10)This safety message is attached to the underside of the access cover to the power guard control. The access cover is located at the back of the rear bumper on the right-hand side of the machine.
g01757733
Crushing Hazard. Do not allow personnel under the machine when you lower the bottom guard. There is no clearance for personnel when the bottom guard is lowered. Read and understand the Operation and Maintenance Manual before performing service/maintenance on the machine. Failure to follow the instructions or heed the warnings could cause serious injury or death.
Improper Connections of The Jump Start Cable (11)
Illustration 9 g01370909
This safety message is located on the underside of the battery compartment access cover on the right-hand side of the machine.
There is limited battery access. Jump starting at the battery, or improper jumper cable connections at the starter, can cause explosion resulting in personal injury.Do not jump start the machine at the battery. Use the remote starting receptacle or jump start to the positive battery post on the starter.If remote starting receptacle can not be used, jumper cables may be used at the starter. Always connect the positive (+) cable to positive (+) terminal of the starter and connect negative (-) cable from external source to engine block. Follow procedure from the Operation and Maintenance Manual.
Pressurized System (12)
Illustration 10 g01371640
This safety message is located on the underside of the access cover for the radiator filler cap.
Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.
Pressurized System (13)This safety message is located on the underside of the access cover to the hydraulic oil filter that is located within the hydraulic oil tank. The access cover is located between the back of the operator cab and the front of the engine compartment.
g01371640
At operating temperature, the hydraulic tank is hot and under pressure.Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly to relieve pressure.