CLIP-2 PIECE 3133406 - Caterpillar

Illustration 1 g00101347
Before you change the flow mode of the hydraulic attachment circuit, place the machine in the servicing position, as shown. Stop the engine.
Illustration 2 g00104483
(1) Ball valve (2) Swing drive (3) Front of the machine
Illustration 3 g00104484
Ball Valve (A) One-way flow (B) Two-way flowUse the manual lever to turn the ball valve. Make sure that you fully turn the ball valve until the ball valve stops.For one-way flow (operation of the hydraulic hammer), position the manual lever parallel to the hydraulic line.For two-way flow (operation of the clamshell or of the shear), position the manual lever so that the lever is perpendicular to the hydraulic line.Never use the manual lever as a step when the manual lever is attached to the ball valve. Remove the manual lever from the ball valve after adjusting the ball valve.