CLIP AS 3598877 - Caterpillar

Image1.1.1
For steps 3 and 4, refer to Image 1.2.1.
3. Loosen and remove bolts (4), washers (5), hose clamps (3) seawater pump hose (1), and clip (2) which hold tube assembly (13) in place. Store seawater pump hose (1), clip (2) and hose clamps (3), bolts (4), and washers (5) for later use. Discard tube assembly (13).
4. Loosen and remove Bolts (4), Washers (5), Hose Clamps (3), Bulk Hose (6), Tube As. (12), Seal (10), and Sleeve (11). Store Hose Clamps (3), Bolts (4), Washers (5) and Bulk Hose (6) for later use. Discard Seal (10), Sleeve (11), and Tube As. (12).
Image1.2.1
For steps 5, 6, 7, and 8, refer to Image 1.3.1.
5. Attach new Tube As. (8) to Aftercooler and Heat Exchanger using new Seal (10), new Sleeve (11), Reuse Bolts (4), Reuse Washers (5), Reuse Bulk Hose (6) and Reuse Clamps (3).
6. Install New Tube As. (7) while Reusing hose (1), Reuse Bulk Hose (6), Reuse Clamps (3), Reuse Bolt, Washer and Clip (2).
7. Install New Tube Assembly (9) to Aftercooler using New Seal (10), New Sleeve (11), New 1/4" Pipe Plug (15) in Boss on Tube As. 178-2285, Reuse Washers (5), Reuse Bolts (4).
8. If the engine is equipped with a Gilkes Sea Water Pump, install the 318-1014 tube between the Gilkes Sea Water Pump outlet and heat exchanger inlet.
9. If the engine has an Engine Mounted Transmission Oil Cooler, install the 319-7432 hose between the Aftercooler outlet and Oil Cooler inlet. Refer to Image 1.3.2. below.
10. Please note that the formed hose will need to be modified for left hand service engines. Refer to Image 1.3.3. below.
Image1.3.1
Image1.3.2
Image1.3.3