CLIP-SENSOR HARN 3762702 - Caterpillar

Disassembly Of The Water Pump
1 Put 5P7356 Spacer (1) on the end of the shaft for the water pump as shown. Fasten 5F7465 Puller (2) to pulley (3) with 1F5842 Bolts (4) and 9N869 Washers. Fasten the pulley in a vise and tighten the screw on puller (2) to remove the pulley from the pump shaft. There must be a minimum of 1.5" (38.1) clearance under the impeller when the pulley is fastened in the vise. 2 Use 5P7354 Pin (5) and a hydraulic press with 4 tons (36 kN) minimum of force to remove the water pump shaft.
Put a suitable guard around pin (5).
3 Use a hammer and a punch to remove the seal assembly from the pump housing. Remove the seat and cup from the impeller. During reconditioning of a water pump, always install a new shaft assembly, seal assembly and cup and seat.Assembly Of The Water Pump
1 Use the hydraulic press and 5P7347 Spacer (1) to install the new 9L7493 Shaft Assembly (2) in the pump housing. Use the hydraulic press and 5P7348 Spacer (3) to install the new 9L8283 Seal Assembly (4) in the pump housing. 2 Use the hydraulic press and the correct plate (5), as follows, to install pulley (6) on the shaft of the water pump. A For installation of pulley (6) on a 3204 Engine water pump, use 5P7349 Plate (5).B For installation of pulley (6) on the water pump of all other engines, use 5P7346 Plate (5). 3 Install the 9L7613 Cup (7) and 9L7612 Seat (8) in impeller (9). Use 5P7355 Plate (10) to push the cup and seat into position.
Do not use a hammer or a hydraulic press to install the cup and seat.
4 Put the pump on the hydraulic press so pulley (6) will face down. Use the correct plate (11) under the center of pulley (6) according to the instructions that follow. C Use 5P7349 Plate as plate (11) for water pumps from 3204 Engines.D Use 5P7346 Plate as plate (11) for all water pumps except for 3204 Engines. 5 Put impeller (9) on the water pump shaft as shown. Put the correct spacer (12) on the pump housing [between the water pump housing and impeller (9)]. Use the correct spacer (12) according to engine model as follows: 1100 and 3100 Engine water pumps - 5P7351 Spacer; 3204 Engine water pumps - use 5P7350 Spacer; 3208 Engine water pumps - use 5P7352 Spacer. 6 Put 5P7353 Spacer (13) on impeller (9) and slowly push the impeller on the pump shaft, until spacer (12) can just be moved between the pump housing and impeller (9). Release the pressure and remove spacer (12). If spacer (12) cannot be removed, turn the pump over, so mounting faces (A) of the pump housing give support to the pump assembly, as near the edge of spacer (12) as possible. Use the hydraulic press and the 5P7354 Pin to push on the pulley end of the pump shaft, just