3C8559 CLIP Caterpillar parts
Rating:
Alternative (cross code) number:
CA3C8559
3C-8559
3C8559
CA3C8559
3C-8559
3C8559
Weight: 2 pounds 1 kg.
For full view, you need register
Information:
Installation Procedure (Input Sensor)
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 594 - Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g01196656
In order to install speed sensor (5), thread in speed sensor (5) until speed sensor (5) lightly contacts a gear tooth. Turn speed sensor (5) counterclockwise for one-half of a turn.
Illustration 2 g01196651
Apply Tooling (A) to both mating surfaces of the gasket. Connect harness assemblies (3). Position cover assembly (4) and the gasket. Install nuts (1) and bolts (2). Installation Procedure (Output Sensor)
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 3 g01196682
Position speed sensor (2) and install bolt (3). Connect harness assembly (1).
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 594 - Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g01196656
In order to install speed sensor (5), thread in speed sensor (5) until speed sensor (5) lightly contacts a gear tooth. Turn speed sensor (5) counterclockwise for one-half of a turn.
Illustration 2 g01196651
Apply Tooling (A) to both mating surfaces of the gasket. Connect harness assemblies (3). Position cover assembly (4) and the gasket. Install nuts (1) and bolts (2). Installation Procedure (Output Sensor)
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 3 g01196682
Position speed sensor (2) and install bolt (3). Connect harness assembly (1).