CLIP 4D4793 - Caterpillar

Illustration 1 g02669324
Alternate Exit (1)
This message is located inside the cab on the right side post by the window latch.
Illustration 2 g02728188If the primary exit is blocked, the window on the right side may be used as an alternate exit. Pull latch backward and push the latch outward in order to open the window to the partial open position. Remove pin from the latch. Push the window open and exit the machine through the window.Air Conditioner (2)
This message is located inside the cab on the left front post.
Illustration 3 g00990500Read the service manual before you perform any maintenance on the air conditioner.No Step (3)
These messages are located on the fenders, on the hood behind the cab, and on the housing below the right side window.
Illustration 4 g01206181Do not step in these locations. Do not stand in these locations.Machine Security System (4)
If equipped, this message is located on the left side of the instrument panel below the engine start switch.
Illustration 5 g01213785This machine is equipped with a security system. Read the Operation and Maintenance Manual before you operate the machine.Payload Control System (PCS) (5)
If your machine is equipped with PCS in Canada, this message will be located on the front dash panel.
Illustration 6 g02105956Machine Hydraulic System (6)
This machine hydraulic system is filled with Cat HYDO Advanced oil. The following message is located by the hydraulic tank.
Illustration 7 g02096113Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for more information about the hydraulic oil.Diesel Fuel Requirements (7)
This message is located by the fuel tank.
Illustration 8 g02157153
Illustration 9 g02052934Use UltraLow Sulfur Diesel (ULSD) fuel.The United States (U.S.) Environmental Protection Agency (EPA) defines Ultra-Low Sulfur Diesel (ULSD - S15) as a U.S. diesel fuel with a sulfur content not to exceed 15 parts per million (ppm(mg/kg)) or 0.0015 percent by weight. Engines certified to nonroad Tier 4 standards (Stage IV in Europe) and are equipped with exhaust aftertreatment systems are designed to run on ULSD only. Use of LSD or fuels higher than 15 ppm (mg/kg) sulfur in these engines will reduce engine efficiency and engine durability. Damage to the emissions control systems and/or shortened service interval will occur. Failures that result form the use of fuels are not Cat factory defects. Therefore the cost of repairs would not be covered by a Cat warranty.In Europe, ultra low sulfur diesel fuel will have a maximum of 0.0010 percent (10 ppm(mg/kg)) sulfur and is typically referred to as “sulfur-free”. This sulfur level is defined in European Standard "EN 590:2004".Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for more information about the fuel.Also, refer to Special Publication, SEBU6250, "Caterpillar Machine Fluids Recommendations" for more information about diesel fuels and sulfur for the Tier 4 requirements.DEO-ULS (8)
UltraLow Sulfur engine oil is required in this engine. This message is located on the engine oil fill.Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for more information about the engine oil.
Illustration 10 g02448560