CLIP 6V4369 - Caterpillar

Marine Engine: C-12 (S/N: K1M1-UP; 9HP1-UP) C12 (S/N: NFL1-UP; C1Z1-UP)Introduction
Do not perform any procedure that is outlined in this Special Instruction and do not order any parts until the entire instruction has been read and understood.This Special Instruction describes the installation procedure for the lip-type seal of the auxiliary water pump. This new lip-type seal helps to ensure that the auxiliary water pump will not leak.Whenever questions arise about this product or about this Special Instruction, contact your local Caterpillar dealer for the latest available information.Safety Information
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Parts List
Table 1
Parts Needed    
Part Number     Description    
359-6660     Shaft    
364-8543 (1)     Seal Kit    
( 1 ) This kit includes the seal installer.Disassembly Procedure
Remove the 359-6661 Auxiliary Sea Water Pump Gp from the engine. Refer to Disassembly and Assembly, "Auxiliary Water Pump - Remove", for more information
Disassemble the 359-6661 Auxiliary Sea Water Pump Gp . Refer to Disassembly and Assembly, "Auxiliary Water Pump - Disassemble", for more information.Assembly Procedure
Table 2
Tools Needed    
Tool     Part Number     Part Description     Qty    
A     1P-0510     Driver Group     1    
B     1P-1859     Retaining Ring Pliers     1    
C     1P-1855     Retaining Ring Pliers     1    
Use Tool (C) to install the retaining ring (24) onto the shaft assembly (8) .
Illustration 1 g00675099
Illustration 2 g00675102
Note: Heat bearings (23) and (26) in an oven to a temperature of 118 °C (244 °F) for no more than 30 minutes before you install the bearings onto the shaft assembly.
Install the spacer (25) onto the shaft assembly (8) .
Illustration 3 g00675182
Use protective gloves to install the bearing (23) onto the shaft assembly (8) .Note: Allow the bearings to cool before installing the shaft into the housing.
Illustration 4 g02256833
Use a press and Tool (A) to install the seal (22) with washer (30) into the body assembly (18) .
Illustration 5 g02255833
(27) Auxiliary water pump shaft (29) Seal installer
Insert seal installer (29), which is provided with the seal kit, onto the splined end of auxiliary water pump shaft (27). Refer to Illustration 5.
Illustration 6 g02256094
Install shaft assembly (8) into body assembly (18) by hand.
Illustration 7 g02256393
Once bearing (26) contacts housing (18), use a press in order to install the shaft into the housing. Refer to Illustration 7.Note: Ensure that the bearing is seated on the housing.
Remove seal installer (29) from the shaft. The tool should slide off the shaft easily, if the shaft is properly installed.
Illustration