CLUTCH UNIT ASSEMBLY 1L5025 - Caterpillar

Table 6
Pin Location     Wire Color     Length of Wire    
1     Blue    
400 mm (15.75 inch)    
2     Black    
200 mm (7.87 inch)    
3     Purple    
200 mm (7.87 inch)    
Locate the 149-Blue wire that is routed to the fuse block. Splice the Blue wire from the 3-pin connector into the 149-Blue wire that is routed to the fuse block. Find the switch connection that is located under the access plate for the console on the right side. Splice the Black wire from the 3-pin connector into one of the 200-Black wires that is routed to the switch connection. Splice the Purple wire from the 3-pin connector into one of the 614-Purple wires that are routed to the switch connection.Note: The switch connection contains the following wires: Purple, Black, Green and White. The white wire is not installed on the 908 Compact Wheel Loaders.
Locate the 3-pin connector that is under the switch plate. The 3-pin connector contains the following wires: 129-Blue Pin A, 200-Black Pin B and 614-Purple Pin C. Remove the connector plug from the connector. Connect the 3-pin connector to the 191-4039 Positioner Harness As (33) .
Route the 191-4039 Positioner Harness As (33) .
Remove the rocker switch plug from the face plate. Connect harness (33) onto the 190-1172 Rocker Switch (30). Install switch (30) into the face plate.
Install the 192-9913 Handle Control Group (35). Connect the cab harness onto handle control group (35). Connect positioner harness as (33) onto handle control group (35) .
Install the 193-9117 Film (37) .Subassembly of the 171-8777 Solenoid Valve and Mounting Group
Illustration 5 g00983826
Install a 3J-1907 O-Ring Seal (2) and a 4J-5477 O-Ring Seal (4) onto the 148-7925 Connector (27). Install connector assembly (27) into Port (P) of the 171-8777 Solenoid Valve and Mounting Group (28) .
Install a 3J-1907 O-Ring Seal (2) and a 4J-5477 O-Ring Seal (4) onto the 6V-8641 Connector (9). Install connector assembly (9) into Port (T) of the 171-8777 Solenoid Valve and Mounting Group (28) .
Install a 3J-1907 O-Ring Seal (2) and a 4J-5477 O-Ring Seal (4) onto the 6V-8627 Elbow (8). Install elbow assembly (8) into Port (C) of the 171-8777 Solenoid Valve and Mounting Group (28) .
Attach the 171-8777 Solenoid Valve and Mounting Group (28) onto the 192-2797 Plate Assembly (34) with the following items: two 8T-4185 Bolts (14), one 8T-4121 Hard Washer (12) and one 4P-8134 Clip (5) .Installing the 171-8777 Solenoid Valve and Mounting Group
Illustration 6 g00983827
Attach the valve assembly onto the inside of the frame with one 8T-4200 Bolt (16) and one 8T-4224 Hard Washer (18). Secure plate (34) at the lower left corner (F) with the existing hardware.
Disconnect the existing 140-9143 Hose As from the pilot solenoid valve. Install two 4J-5477 O-Ring Seals (4) onto the 6V-9835 Tee (10). Install tee assembly (10) onto the existing elbow