CLUTCH & RING AS 3V0908 - Caterpillar

Illustration 1 g06115636
Left-Hand Console Cover
Illustration 2 g06115640
Right-Hand Console Cover
A new procedure for routing of the wire harness for the console covers has been improved. The wire harness is improved by removing the wire braiding, retape the wire harness, and covered with convoluted tubing for insulation. This braiding removal reduces undue stress on the console cover where the harness comes through the console cover. See Illustration 1 and 2 for the location of improvement.Adaptable To: The following changes are adaptable to the products within the listed serial numbers, and are effective with all products after the listed serial numbers.Routing Procedure
Illustration 3 g06115647
(A) Right-Hand Console Cover
Illustration 4 g06115652
(B) Left-Hand Console Cover
Remove 390-3841 Console As (RH) and 390-3846 Console (LH).
Reposition the harness to ensure that the harness is routed along side of the weld link and not on top of the weld link. Ensure that the harness lays flat and does not apply any upward pressure on the console cover.
Ensure the head of the tie-strap is away from the console cover.
Illustration 5 g06115687
Illustration 6 g06115689
Remove the braiding from the wire harness and tape the section that comes through the console cover.
Reinstall the two console covers.