CLUTCH GP 4498082 - Caterpillar

General Information
The harness code connector, the service connector for the 4C-8195 Control Service Tool (switch box), and the diagnostic service tool connector are located behind the fuse access cover in the right rear panel of the cab.The power train electronic control module (ECM) is located in the right rear corner of cab.The Electrical System Schematic, Parts Manual, and Operation and Maintenance Manual for the machine that is being serviced should be used to locate electrical components and connectors.The following information is a guide to reading the tables on the back of the Electrical System Schematic.
The "Component Location" table uses white circles to mark the locations in the profile of the machine and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.
The "Harness Connector Location" table uses white circles to mark the locations in the general view and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.Reference: For more information on the operation of the machine, refer to the Service Manual module Operation and Maintenance Manual, "988G Wheel Loader".Reference: For more information on the operation of the electrical components of the machine, refer to the appropriate Parts Manual for your machine.Connectors for Power Train ECM
Illustration 1 g00684507
Power Train ECM (1) Connector J1. (2) Connector J2.
Illustration 2 g00684512
Power Train ECM (3) Screw.To remove the machine harness from the power train ECM, use screw (3) in the center of the harness connector.