CLUTCH GP-STEERING 5G8725 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03416427
Slide locking tab (2) into the unlocked position. Disconnect harness assembly (1) from camshaft position sensor (3).
Remove bolt (4). Carefully remove camshaft position sensor (3) from the cylinder block. Note: Do not use a lever to remove the camshaft position sensor.
Remove O-ring seal (5) from camshaft position sensor (3). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g03416427
Install a new O-ring seal (5) to camshaft position sensor (3). Note: Do not lubricate the O-ring seal.
Install camshaft position sensor (3) to the cylinder block. Install bolt (4) and tighten the bolt to a torque of 14 N m (124 lb in).
Connect harness assembly (1) to camshaft position sensor (3). Slide locking tab (2) into the locked position.