CLUTCH GP-BASIC 5N1730 - Caterpillar

Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     3S-6224     Electric Hydraulic Pump Gp     1    
6V-3175 Double Acting Cylinder     1    
4C-9634 Puller Stud     1    
9U-6832 Nut     1    
6V-4035 Sleeve     1    
B     3S-6224     Electric Hydraulic Pump Gp     1    
6V-3175 Double Acting Cylinder     1    
6V-4035 Sleeve     1    
4C-9634 Puller Stud     1    
9U-6832 Fast Runner Nut Assembly     1    
C     3S-6224     Electric Hydraulic Pump Gp     1    
6V-3175 Double Acting Cylinder     1    
4C-9634 Puller Stud     1    
9U-6832 Fast Runner Nut Assembly     1    
5P-8601 Bearing Puller Adapter     1    
7F-6068 Sleeve Assembly     1    Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Stop the machine so that the bucket is positioned flat on the ground.
Illustration 1 g00391837
Attach a suitable lifting device to bucket tilt link (1) . The weight of bucket tilt link (1) is approximately 54 kg (120 lb).
Remove bolt (2) , the washer, and the spacer from pin assembly (3) .
Illustration 2 g00880756
Attach a suitable lifting device to Tooling (A) . The weight of Tooling (A) is approximately 34 kg (75 lb).
Use Tooling (A) to remove pin assembly (3) .
Illustration 3 g01202012
Reposition the suitable lifting device on tilt link (1) , as shown.
Illustration 4 g00348514
Remove bolt (4) , the washer, and the spacer from pin assembly (5) .
Illustration 5 g00348515
Use Tooling (B) in order to remove pin assembly (5) .
Use the suitable lifting device in order to remove bucket tilt link (1) .
Illustration 6 g00348516
Remove lip seals (6) from both sides of bucket tilt link (1) . Repeat this step for the opposite end of the bucket tilt link (1) .
Illustration 7 g00348652
Use Tooling (C) in order to remove the bearing from bucket tilt link (1) . Repeat this step for the opposite end of bucket tilt link (1) .