CLUTCH AS-SPRAG 7G6877 - Caterpillar

Specify the Orientation of the Arm Sensor
Before the arm sensors can be used, you must specify the segment of the arm each sensor is mounted on. Only one arm sensor at a time can be connected to the system harness during the configuration procedure. Ensure that only one sensor is connected to the harness during the configuration. Failure to connect only one Angle Sensor at a time could render the sensors unusable.
Make sure that you complete this process before you calibrate the arm sensors. If you do not set the sensor orientations correctly, future calibration results will be invalid and bucket guidance will be inaccurate.
Note: The orientation of an arm sensor describes the side of the arm that the sensor is mounted on.In order to set the orientation of the arm sensor, complete the following steps:
Press the "Setup Menu" soft key.
Press the "Installation" soft key.
Illustration 1 g01453749
Use the arrow keys in order to highlight "Calibrate Sensors". Press the "OK" key.
A screen that is similar to Illustration 2 will appear.
Illustration 2 g01217606
Use the up arrow button or the down arrow button in order to highlight "AS300C Sensor Orientations". Press the "OK" key.
A screen that is similar to Illustration 3 will appear.