COIL 2G8921 - Caterpillar

Table 1
Message Description
Loading Continue to load the truck.
Fully Loaded The truck is fully loaded.
Last Pass An additional pass is required to load the truck fully. Various payload parameters can be accessed via the display menus at any time during the load cycle.Note: The last pass indicator works correctly in loading applications that require at least three loader passes. When a loader pass is used to spot the truck, a minimum of four loader passes are necessary for the last pass indicator to work.
Illustration 1 g02570918
(1) Typical external payload display (Scoreboard)The optional external payload display (Scoreboard) (1) provides feedback to the loader operator during the loading operation. The external payload display provides the loader operator with a digital readout of the payload weight.Whenever the physical configuration of the truck has been changed, a manual calibration must be performed. The calibration procedure is performed when the truck is empty. The replacement of the suspension cylinders is an example of a condition that would require a manual calibration."Automatic recalibration" of a truck occurs when an empty truck has stopped. This calibration will compensate for conditions that can affect the empty weight of the truck. Carryback weight and fuel weight are two variable conditions that will affect the weight of an empty truck.Some parameters can be modified with the service tool to support a wide range of machine configurations.Information such as "total number of loads hauled" and "total weight hauled" can be shown on the display. These totals can be reset by the operator via the display. For example, you can use this function to reset the totals prior to a shift change.Onboard TPMS Features
Onboard TPMS features are listed below.
Calculate information for the payload cycle from the recorded data. Record the calculated information for the payload cycle. The information for the following variables is recorded for each payload cycle.Time stamp - The "Date/time" that marks the start of the payload cycle.Payload - The weight of the material that is being moved.Loading Time - The amount of time that is required to load the truck.Stopped Empty Time - The "total time" that is recorded for a truck that is "stopped while empty" during the payload cycle.Traveling Empty Time - The "total time" that is recorded for a truck that is "traveling while empty" during the payload cycle.Travel Empty Distance - The "total distance" Traveled by the truck while the truck was empty.Stopped Loaded Time - The time that is recorded when a truck with a full load is not moving during the payload cycle.Traveling Loaded Time - The time that is recorded when a truck with a full load is moving during the payload cycle.Transmission Shifts - The total number of transmission shifts that were made during the payload cycle.Used Fuel - The total fuel that is used during the payload cycle.ID of the Operator - The identification number of the operator that had dumped the load for that payload cycle. The operator must enter this number via the display keypad module. This identification