COIL 3352155 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00591631
Ensure that the O-ring seals are in position on tubes (2) and (9). Place clean engine oil on the seals.
Attach a suitable lifting device to engine oil cooler (10) and install tube (2).
Install engine oil cooler (10) on tube (9). Ensure that tube (2) is in the correct position in the adapter of the engine oil filter housing.
Install two bolts (8).
Install two bolts (11) and remove the lifting device.
Illustration 2 g00591629
Place clean engine oil on the O-ring seal on the end of tube (7). Install elbow (6) and tube (7) in the engine oil cooler bonnet. Ensure that the gasket is in place and install the bolts.
Illustration 3 g00591628
Install the gasket and the bolts that hold flange (5) and tube (4).
Install clamp (1) and the bolts that hold tube (2) on the engine.
Install retainers (3) and the bolts on the ends of tube (2).
Check the oil level in the engine. Add engine oil, if necessary. Fill the coolant system to the correct level with coolant. Refer to the Operation and Maintenance Manual for the correct procedure.