COIL AS-EVAPORATOR 3965842 - Caterpillar

Specifications
Table 1
Specifications for 361-1225 Engine Oil Cooler Gp    
Callout     Part Number     Part Name     Specification Description    
2     -     Bolt     Initial torque...................
10 N m (89 lb in)
Tighten the bolts in the sequence that is in illustration 5.
Final torque...................
26 N m (19 lb ft)
Tighten the bolts in the sequence that is in illustration 6.    Removal Procedure
Start By:
Remove the Electronic Control Module (ECM). Refer to Disassembly and Assembly, "Electronic Control Module" for the correct procedure.
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorized personnel that have the correct training.Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information. Refer to System Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Drain" for the correct procedure.
Illustration 1 g02475489
Illustration 2 g02475493
Remove spacer (1) (not shown) from the cylinder block.
Remove bolt (2) from the assembly of engine oil cooler (3) .Note: Support the engine oil cooler as the bolts are removed.
Remove the assembly of engine oil cooler (3) from the cylinder block.
Remove gasket (4) from engine oil cooler (3) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g02475493
Illustration 4 g02475489
Ensure that engine cooler (3) is clean and free from damage. Ensure that the engine oil cooler is free from restriction.
Position a new gasket (3) onto engine oil cooler (2) .
Push bolts (1) through the holes in the gasket.Note: The holes in the gasket have serrations that hold the bolts captive.
Clean the gasket surfaces of the cylinder block.
Position engine oil cooler (3) onto the cylinder block. Hand tighten bolts (2) .
Illustration 5 g02600976
Initial tightening sequence
Tighten the bolts to an initial torque of 10 N m (89 lb in) in the sequence that is shown in Illustration 5.
Illustration 6 g02600977
Final tightening sequence
Tighten the bolts to a final torque of 26 N m (230 lb in) in the sequence that is shown in Illustration 6.
Install spacer (1) (not shown). Tighten the bolts to a torque of 44 N m (32 lb ft). Refer to Illustration 4End By: Install the Electronic Control Module (ECM). Refer to Disassembly and Assembly, "Electronic Control Module" for the correct procedure.