COLLAR-TRACK ROLLER 1321951 - Caterpillar

Parameters Worksheet
Note: A mistake in recording this information will result in incorrect passwords.
Table 3
Engine Parameters
ECM Identification Parameters
"Equipment ID"
"Engine Serial Number"
"ECM Serial Number"
"Software Gp Part Number"
"Software Gp Release Date"
Selected Engine Rating
"Rating Number"
"Rated Power"
"Rated Peak Torque"
"Top Engine Speed Range"
"Test Spec"
"Top Engine Limit"
"Engine Accel Rate"
"Low Idle Speed"
"PTO Mode"
"High Idle Speed"
"Intermediate Engine Speed"
"Maximum Engine Torque Limit"
"Customer Password #1"
"Customer Password #2"
"FLS"
"FTS"
"Ether Control"
"Air Shutoff"
"Maintenance Indicator Mode"
"PM1 Interval"
"Throttle Position Sensor"
"Coolant Level Sensor"
"Last Tool to change Customer Parameters"
"Last Tool to change System Parameters"
"Aux Press Temp Installation Status"
"Aux Press Sensor Installation Status"
"Total Tattletale"
Information from Engine Information Plate
"Engine Serial Number"
"FLS"
"FTS"
Injector Codes
Injector Code (1)
Injector Code (2)
Injector Code (3)
Injector Code (4)
Injector Code (5)
Injector Code (6)
Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Only change the FLS and the FTS because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine. The use of the wrong parameters may also void the Caterpillar warranty.