AVSPARE.COM
parts catalog

COLLAR-TRACK ROLLER 6Y2791 - Caterpillar


6Y2791 COLLAR-TRACK ROLLER Caterpillar parts 1290T, 330, 330 FM L, 330 L, 330B L, OEMS, TK732, TK751, TK752
Rating:
68
Alternative (cross code) number:
CA6Y2791
6Y-2791
6Y2791
Caterpillar 6Y2791 COLLAR-TRACK ROLLER
Weight: 11 pounds 5 kg.

Buy COLLAR-TRACK ROLLER 6Y2791 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, UNDERCARRIAGE,

Compatible equipment models: 6Y2791:

EXCAVATOR  330   330 FM L   330 L   330B L  
TRACK FELLER BUNCHER  1290T   TK732   TK751   TK752  
UNDERCARRIAGE  OEMS   Caterpillar
Number on catalog scheme: 10
  For full view, you need register

Information:


Illustration 1 g00562900
Hoist Control Valve
(1) Solenoid Valve (Hoist Enable).
The location for the Solenoid Valve (Hoist Enable) is under the chassis between the transmission and the torque converter.
Illustration 2 g02538337
Schematic Of The Solenoid Valve (Hoist Enable)
Note: The approximate coil resistance of the solenoid is 41 ohms at 25 °C (77.0 °F).This diagnostic code is associated with the Solenoid Valve (Hoist Enable). The FMI 06 means that the ECM has determined that the current of the solenoid is above normal.The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This situation is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1243 FMI 06 is active before performing this procedure.Note: Use a calibrated 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The ECM will turn off the solenoid for the hoist pilot system enable. This will cause the hoist system to be forced to the HOLD mode.After the diagnostic goes away, the ECM will continue to command the system to be in the HOLD mode until the hoist lever is moved into the HOLD mode.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness.Expected Result:CID 1243 FMI 06 changes to CID 1243 FMI 05 when the solenoid is disconnected.Results:
YES - CID 1243 FMI 06 changes to CID 1243 FMI 05 when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" to verify the solenoid failure. Replace the solenoid.STOP
NO - CID 1243 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND.
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connectors from the ECM.
At the machine harness connector, measure the resistance from the signal contact J1-66 (wire J826-PK(Pink)) to all contacts that are used in the machine harness connectors for the ECM.Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J1-66 (wire J826-PK(Pink)) and the circuit with the low-resistance measurement.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 1243 FMI 06.Expected

Caterpillar parts catalog:

Caterpillar parts catalog
CIPI Undercarriages L5E00001-UP (MACHINE)
330 CIPI Excavator Track Systems L5E00001-UP (MACHINE)
TK732 Track Feller Buncher 10400001-UP (MACHINE) POWERED BY C-9 Engine
1290 T Track Feller Buncher BZM00001-UP (MACHINE)
TK751 Track Feller Buncher 30100001-01114 (MACHINE) POWERED BY C-9 Engine
TK752 Track Feller Buncher 30200001-UP (MACHINE) POWERED BY C-9 Engine
330, 330L Excavators 2ZM00001-UP (MACHINE)
330B L Excavator 6DR00001-UP (MACHINE) POWERED BY 3306 Engine
330B L, 330B LN Excavators 3YR00001-UP (MACHINE) POWERED BY 3306 Engine
330B & 330B L Excavators 4RS00001-UP (MACHINE) POWERED BY 3306 Engine


Parts collar Caterpillar catalog:

1006532 COLLAR-ALTERNATOR
120G, 120H, 120H ES, 120H NA, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 16G, 16H NA, 24H, 30/30, 3114, 3116...
8E5037 COLLAR-TRACK ROLLER
311, 311B, 311C, 312, 312B, 313D2 LGP, 315, 315B, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320B FM LL, 320B L, 320C, 3...
7H4571 COLLAR ASSEM.
235, 572G, 572R, 572R II, 953C, 963B, 963C, 973, 973C, 973D, 977D, 977H, 977K, D5H, D5H XL, D6H, D6H XL, D6M, D6N, D6R, D6R II, D6R III, D7E, D7F, D7G, D7G2, D7H, D7R, D7R II, D7R XR, OEMS
1319352 COLLAR-TRACK ROLLER
953C, D5H, D5H XL, D5HTSK II, D6M, D6N, OEMS
1787296 COLLAR-TRACK ROLLER
325D FM, 325D FM LL, 330C, 330C FM, 330D FM, 330D L, 330D MH, 345B, 345B II, 345B II MH, 345B L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 365C L, 568 FM L...
1588086 COLLAR-TRACK ROLLER
1090, 1190, 1190T, 1390, 2290, 2390, 2391, 320B, 320C, 322B, 322B L, 322B LN, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 324E, 324E L, 324E LN, 325B, 325B L, ...
6Y1054 COLLAR-TRACK ROLLER
320B, 322, 322 FM L, 322 LN, 322B L, 322B LN, 325, 325 FM L, 325 LN, 325B, 325B L, OEMS
2128086 COLLAR
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 551, 552, 552 2, TK711, TK721, TK722, TK732, TK741, TK751, TK752
1718671 COLLAR
324D, 324D L, 324D LN, 325D, 325D L, 329D L, 329D LN, 329E L, 329E LN, 330B L, 330C L, 330D L, 330D LN, 336D L, 336D LN, 336E LN, 345D L, 345D L VG, 349E L VG, CW-10
8E9723 COLLAR - ROLLER END
325 L, 325 LN, 330 FM L
2128086 COLLAR
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 551, 552, 552 2, TK711, TK721, TK722, TK732, TK741, TK751, TK752
2264015 COLLAR
533, 543, HA770, HA771, HA870, HA871, TK370, TK371, TK380, TK381
1728482 COLLAR
320C, HEX-WEDGE
3452959 COLLAR-TRACK ROLLER
322C, 324D, 324D FM, 324D FM LL, 324D L, 324E, 324E L, 325D, 325D FM, 325D FM LL, 325D L, 326D L, 329D, 329D L, 329E, 329E L, 330D L, 336D L, 336D LN, 336E, 345D, 349D L, OEMS
3452958 COLLAR-TRACK ROLLER
322C, 324D, 324D FM, 324D FM LL, 324D L, 324E, 324E L, 325D, 325D FM, 325D FM LL, 325D L, 326D L, 329D, 329D L, 329E, 329E L, 330D L, 336D L, 336D LN, 336E, 345D, 349D L, OEMS
6Y1054 COLLAR-TRACK ROLLER
320B, 322, 322 FM L, 322 LN, 322B L, 322B LN, 325, 325 FM L, 325 LN, 325B, 325B L, OEMS
3622868 COLLAR-SLIDING
2470C, 2570C, 2670C, 2864C, 553C, 563C, 573C, 586C
1718671 COLLAR
324D, 324D L, 324D LN, 325D, 325D L, 329D L, 329D LN, 329E L, 329E LN, 330B L, 330C L, 330D L, 330D LN, 336D L, 336D LN, 336E LN, 345D L, 345D L VG, 349E L VG, CW-10
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.