COLLAR ASSEM. 7M1849 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of all maintenance which includes the following items: performing all adjustments , using proper lubricants, fluids, and filters and replacing old components with new components due to normal wear and aging .Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Choose the interval that occurs first in order to determine the correct maintenance interval: fuel consumption , service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance. All of the following will affect the oil change interval: operating conditions , fuel type , oil type and size of the oil sump . Scheduled oil sampling analyzes used oil in order to determine if the oil change interval is suitable for your specific engine. Refer to this Operation and Maintenance Manual , "Engine Oil and Filter - Change" in order to determine the oil change interval that is suitable for your specific engine.To determine the maintenance intervals for the overhauls, refer to this Operation and Maintenance Manual , "Maintenance Recommendations" .When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Engine Air Cleaner Element (Dual Element/Box Type) - Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Fuel Tank Water and Sediment - Drain
Radiator - Clean
Daily
Air Tank Moisture and Sediment - Drain
Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check
Walk-Around Inspection
Every 250 Service Hours
Engine Oil Sample - Obtain
Grounding Stud - Inspect/Clean/Tighten
Initial 500 Service Hours
Engine Valve Lash - Check
Every 500 Service Hours
Battery Electrolyte Level - Check
Belts - Inspect/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Hoses and Clamps - Inspect/Replace
Every 2000 Service Hours
Air Shutoff - Test
Fumes Disposal Filter Element - Replace
Every 2000 Service Hours or 1 Year
Coolant Sample (Level 2) - Obtain
Every 2500 Service Hours
Compression Brake - Inspect/Adjust/Replace
Electronic Unit Injector - Check/Replace
Engine Valve Lash - Check
Valve Actuators - Check
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Every 4000 Service Hours
Air Compressor - Check
Engine Mounts - Inspect
Starting Motor - Inspect
Every 5000 Service Hours
ARD Spark Plug - Replace
Diesel Particulate Filter - Clean/Replace
Fuel Priming Pump - Replace
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
Every 585 000 L (154 540 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations