COLLET CLAMP 5P4814 - Caterpillar

See the topic "Assembly And Installation Of Conventional Duo-Cone Seals" in this module.
The rubber seals and all surfaces that make contact with the seals must be clean and dry. After installation of the seals, put clean SAE 30 oil on the contact surfaces of the metal seals.36. Using Tool (E), install Duo-Cone seal (37) in end housing (40) and in main housing (36).37. Reinstall main housing (36) on end housing (40).38. Reinstall shim (33) in the main housing. 39. Put gear (32) in its original position in the main housing.40. Put 9S-3263 Thread Lock on the threads of 22 socket head bolts (31) that hold gear (32) in position. Install the socket head bolts, and tighten them evenly to a torque of 1000 125 N m (740 90 lb ft).41. Assemble carrier assembly (25) as follows: a. Put clean SAE 30 oil on bearing (30). Install bearing (30) in planetary gear (29).b. Put a thrust washer (28) on each side of planetary gear (29). Install the planetary gear and thrust washers in the carrier.c. Install planetary shaft (27) in the carrier and through the planetary gear. Make sure the spring pin hole in the planetary shaft is in alignment with the spring pin hole in the carrier.d. Install spring pin (26) in the carrier and into the planetary shaft. Install the spring pin until it is 2 to 3 mm (.078