COMBUSTION GP-EXHAUST 2893362 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 504-9791 Lift Gp (60Hz)(1) 1
OR
504-9793 Lift Gp (50Hz)(2) 1
B 1U-7498 Support Stand As 1
1U-7501 Extension Tubes 1
C 8S-7610 Base As 1
8S-7650 Cylinder As 1
4C-5809 Electric Hydraulic Pump Gp 1
E 142-8548 Lifting Bracket As 1
5P-8622 Shackle 2
(1) High-Voltage (480V) Low-Voltage (240V)
(2) High-Voltage (400V) Low-Voltage (200V)Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g06267154
Typical example
Position Tooling (A) as shown. Use Tooling (A) to raise the front of the machine. Refer to Tool Operating Manual, NEHS1303, "Lift Group (Stand - 25 Ton)" for more information.
Illustration 2 g00867135
Use Tooling (C) to raise the rear of the machine. Raise the machine so the roller frame will clear the track. Install Tooling (B).
Illustration 3 g01219536
Attach a suitable lifting device to Tooling (E), as shown.
Illustration 4 g00867143
Use Tooling (E) to install track roller frame (4) . The weight of track roller frame (4) is approximately 1860 kg (4100 lb). Remove Tooling (E) from track roller frame (4).
Illustration 5 g00867145
Install retainer (9) and bolts (8).
Illustration 6 g01219535
Install the equalizer bar pin (7). Install bolts (6) and washer (5).
Illustration 7 g01397731
Install plate (3).
Illustration 8 g00867138
Install trunnion (2). Refer to Disassembly and Assembly, "Trunnion - Remove and Install".
Illustration 9 g00867137
Install hand rail (1).End By:
Connect the track.