COMPRESSION SP 0850720 - Caterpillar

Illustration 1 g01323189
Place the system in test mode by removing "test mode" plug (1). Make sure that the parking brake is in the ON position.Note: On CB-564D machines, remove the "model config" plug. The plug is located near the fuse box. On some machines, the side console cover may need to be removed in order to access the plug. The plug should then be moved to a more accessible location for future service.
Turn the key to the ON position. Do not start the engine.
If there are any fault codes, do not proceed to the next step. A series of long flashes and short flashes of the light for the parking brake will indicate fault codes. Refer to Table 1 for the fault codes.
Table 1
Fault Code    Fault Code    
11     Brake Switch    
12     Propel Control Handle    
13     Speed Control    
14     Solenoid for the Forward EDC    
15     Solenoid for the Reverse EDC    
16     Calibration of the Propel Control Handle    
17     Calibration of the Speed Control    
18     Calibration of the Forward EDC    
19     Calibration of the Reverse EDC    
22     Offset Switch    
28     CCW Offset    
29     CW Offset    
31     Brake Solenoid    
32     Solenoid of the Valve for the Shunt    
41     Water Timer    
42     Calibration of the Water Timer    
43     Water Mode    
44     Water Switch ON Position    
51     Propel Mode    
52     Neutral Fault    
53     Machine Type    
54     Backup Alarm    
55     Neutral    
61     Vibe Configuration    
62     Vibe Forward    
63     Vibe Reverse    
64     Vibe Hi/Lo    
91     Sensor Power    
Illustration 2 g01534697
The connector is directly under the potentiometer inside the console.
Disconnect water potentiometer (2) from the harness and connect water potentiometer (2) within five seconds. This will initiate water potentiometer (2) for calibration.
Rotate water potentiometer (2) clockwise to the maximum position.
Illustration 3 g01534715
Press button (3) .
Rotate water potentiometer (2) counterclockwise to the minimum position.
Press button (3) .
The light for the parking brake switch will flash twice in order to confirm that the calibration was accepted.Note: If calibration is not successful, a fault code will be displayed on the light for the parking brake switch. If the calibration is not successful, cycle power with the key and attempt the calibration again.Note: If a calibration fault cannot be remedied by repeating the calibration process, it is recommended that the default values be restored. Refer to Testing and Adjusting, KENR3615, "Propel Control−Calibrate".
Connect plug (1) to the connector with the "Model Config" label. See Illustration 1.Note: Recycle the power in order to end the "Model Config".