COMPRESSOR A 0681504 - Caterpillar

Bucket Stop Replacement Procedure
Note: If replacement bucket stops are required contact your Caterpillar dealer for bucket stop manufacturing details.
Remove the existing bucket stops. Leave the bucket plates intact.
Raise lift arms (3) until dimension (C) measures 277 mm (10.9 inch).
Tilt bucket (2) back until dimension (A) measures 1275 mm (50.19 inch).
Ensure that bucket (2) is safely supported.
Install the tapered bucket stops with the tapered end down. Move the bucket stops until they contact the lift arms. Tack weld the bucket stops to bucket (2) .
Lower the bucket to the ground and fully weld the bucket stops to the bucket with a full penetration butt weld and a 16 mm (0.63 inch) fillet weld on the two vertical sides only.
Check