COMPRESSOR C 0788154 - Caterpillar

Always engage the parking brake and transmission neutral lock before dismounting the machine, operating the backhoe or engaging the boom lock for the transport position. Failure to do so could allow unexpected machine movement, resulting in personal injury or death.
When you operate the backhoe, engage the parking brake. Also, place the transmission in NEUTRAL and engage the transmission neutral lock.Only operate the machine while you are in a seat. The seat belt must be fastened while you operate the machine. Only operate the controls while the engine is running.While you operate the machine slowly in an open area, check for proper operation of all controls and all protective devices.Before you move the machine, ensure that no one will be endangered.Do not allow riders on the machine unless the machine has the following equipment:
additional seat
additional seat belt
Rollover Protective Structure (ROPS)Note any needed repairs during machine operation. Report any needed repairs.Carry work tools approximately 400 mm (15.7 inch) above ground level. Do not go close to the edge of a cliff, an excavation, or an overhang.If the machine begins to sideslip downward on a grade, immediately remove the load and turn the machine downhill.Avoid any conditions that can lead to tipping the machine. The machine can tip when you work on hills, on banks and on slopes. Also, the machine can tip when you cross ditches, ridges, or other unexpected obstacles.Avoid operating the machine across the slope. When possible, operate the machine up the slopes and down the slopes.Maintain control of the machine. Do not overload the machine beyond the machine capacity.Be sure that the hitches and the towing devices are adequate.Only connect the trailing equipment to a drawbar or to a hitch.Never straddle a wire cable. Never allow other personnel to straddle a wire cable.Before you maneuver the machine, make sure that no personnel are between the machine and the trailing equipment. Block up the hitch of the trailing equipment in order to align the hitch with the drawbar. Maneuver the machine. Connect the machine to the trailing equipment.Know the maximum dimensions of your machine.Always keep the Rollover Protective Structure (ROPS) installed during machine operation.Observe any local government regulations when you use the backhoe loader to lift heavy objects.