COMPRESSOR GP-REFRIGERANT 3453584 - Caterpillar

1. Loosen setscrew (1), and remove pedal (2) from the shaft. 2. Remove four bolts (4), and remove pedal housing (3) from the floor plate. 3. Remove two bolts (7) and bar (6) from cover assembly (8).4. Remove three bolts (5) and cover assembly (8) from pedal housing (3). 5. Remove bearing (9) from cover (8).
Do not bend the rod of the cable assembly out away from pedal housing (3) more than 8° when removing the cotter pin and pin (14) that connects the rod end of the cable assembly to lever (12). This will cause damage to the cable assembly and shorten the service life of the cable assembly.
6. Remove cotter pin (13) and pin (14) that connects the cable assembly to lever (12).7. Remove lever (12) and shaft (11) as a unit and two washers (10) from the governor pedal housing. 8. Remove bolt (15) from lever (12).9. Remove shaft (11) and the key from the lever.10. Remove the key from shaft (11). 11. Remove rod end (20), guide (19), spring (18) and guide (17) from cable assembly (16). 12. Loosen bulkhead nut (21), and remove housing (3) from cable housing (16). 13. Remove bearing (22) from housing (3). 14. Remove the bolt that connects clip (23) and cable assembly (16) to the plate assembly. 15. Remove six screws (24) and cover (25) from the governor housing. 16. Remove bolt (31), and disconnect rod end (30) from lever (27).17. Remove lever (27) from the shaft.18. Loosen nut (29), and remove rod end (30) from the cable assembly.19. Remove nut (28) that holds the cable assembly in position in governor housing (26).20. Remove two bolts (32) that hold governor housing (26) to the governor.21. Remove the governor housing from the governor and the cable assembly.22. If necessary, remove the seal from the governor housing.Assemble And Install Governor Pedal And Housing Group
1. Use tooling (A), and install bearing (2) in governor pedal housing (1). Make sure the bearing is installed with the stamped side out and even with the outside surface of the housing. Place tooling (A) against the stamped side when installing the bearing.
Typical Example2. Install the seal and nut (4) on cable assembly (3) until they are against the shoulder of the cable assembly.3. Install pedal housing (1) on cable assembly (3) until it is against the seal and nut (4). 4. Install guide (5), spring (6), guide (7) and rod end (8) on cable assembly (3). Make sure guide (7) and rod end (8) are installed all the way on the cable assembly. 5. Install the key in the keyway of shaft (9).6. Put shaft (9) in position in the bore of lever (11), and install bolt (10) that holds it in place. Make sure the key is centered in the bore of lever (11).
Typical Example7. Install bearing (12) on shaft (9).8. Install shaft (9) and lever (11) in the governor pedal housing as a unit.
Typical Example
Typical Example
Do not bend rod (13) of cable assembly