COMPRESSOR GP-REFRIGERANT 5044008 - Caterpillar

"GPS Fix Validity Time Duration" Screen
Illustration 9 g01360606
"GPS Fix Validity Time Duration" Screen
"Preferred Wireless Service Configuration" Screen
Illustration 10 g01361300
"Preferred Wireless Service Configuration" Screen
Installation Parameters Configure for PL321SR System (PL121SR Radio and PL300 ECM)
Ensure that steps have been taken in order to connect the computer with CAT ET software properly to the Product Link system. Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Configuration".
Click the "Connect" icon or click "File" on the menu bar. Click "Connect" from the selections on the pull-down menu in order to establish communication with the PL321SR System.
Select the "Product Link" from the "Select an ECM" field.
Illustration 11 g01119224
"Select an ECM" Screen
Click "OK".
Once you are connected, click the "Configuration Tool" icon or select the "Service" menu," Configuration" drop-down item in order to view the configuration screen.
Highlight "Product Link" and then click "Expand All".
Illustration 12 g01361816
PL321 Configuration Screen
Double click the desired parameter or select the desired parameter and click "Change". A dialog box will appear. Also, a list will appear that will show all of the possible parameter values. Note: "PLM Installation Parameters" section cannot be changed in the Configuration screen. These parameters must be changed using the "Service " menu, "Product Link Registration" drop-down option.
Click "OK" after changing each parameter in order to return to the configuration screen. Note: The "Report Start Time" parameter should be set to generate reports while the machine is powered up to avoid having a time designated for the system to report while the machine is powered down.Refer to the "Machine Serial Number" for information about the "Product ID" that is used in the Product Link system. Refer to Illustration 2 for an example of a machine serial number.Refer to Table 2 for an explanation of the parameters for installation.Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Report Parameters Configure" for an explanation of the parameters (report). Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Wireless Service Configure" for an explanation of the parameter (wireless service). Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Spare Input Configure" for an explanation of the parameters (spare input).
Table 2
PLM Installation Parameters
Parameter Description Configuration Notes
Maintenance Mode The Maintenance Mode is used to prevent diagnostic and event messages from being reported when performing maintenance on the machine.
This value should be reverted to "Off" after the servicing is complete. This value also reverts to "Off" after 12 calendar hours in order to ensure proper operation (long term) of the system. If an event (diagnostic) does occur when the Maintenance Mode is active, the event (diagnostic) is ignored until the Maintenance Mode is turned off. Remember to clear any diagnostic codes that were created during maintenance. If you do not remember, the diagnostic codes will be transmitted once the Maintenance Mode is turned off. To disable the PLM from sending any diagnostic or event messages while performing maintenance, select the "On" value.
To continue normal operation of the Product Link system after maintenance is done, select the "Off" (default) value.
Machine Serial Number The Machine Serial Number is used by the Product Link