COMPRESSOR GP 7E7740 - Caterpillar

Enter the Product Link Module (PLM) Installation Parameters last to ensure proper registration. Select the configuration screen by selecting the icon on the toolbar or by using the pull-down menu as shown in Illustration 36.There are three ways to access the configure screen:
Select “Service” then select “Config” on the menu bar.
Press the “F5” key.
Select the “Configuration Tool” icon on the toolbar.
Ensure that steps have been taken to connect the computer with CAT ET software to the PL522 / PL523 system. Refer to “Connecting a Computer to the PL522 / PL523 System”.
Click the "Connect" icon or click "File" on the menu bar, then click "Connect" from the pull-down menu selections to establish communication with PL.
After the computer has connected to PL522 / PL523 system, click the "Configuration Tool" icon or select the "Service – Configuration" menu item to view the Configuration screen.
Double click the desired parameter or select the desired parameter and click "Change". A dialog box will appear, along with a scroll-down list, showing all the possible parameter values. Note: The “PLM Installation Parameters” section cannot be changed in the Configuration screen. These parameters must be changed using the “Service - Product Link Registration” option.
Click the "OK" button after changing each parameter to return to the Configuration screen. Refer to Illustration 36 which shows a non-Caterpillar “DBS Machine Make Code” example.Note: For a non-Caterpillar machine, the serial number can be any alpha-numeric characters up to 17 characters long.Refer to the following for information when entering information for a Caterpillar Machine. When the machine serial number is entered, only the last eight digits are to be entered.
Illustration 38 g02220113
(1) Caterpillar World manufacturing code (characters 1-3)
(2) Machine description (characters 4-8)
(3) Check character (character 9)
(4) Machine Indicator Section (MIS) or Product Sequence Number (characters 10-17). These characters were previously referred to as the Serial Number. First Quarter 2001, the Caterpillar Product Identification Number (PIN) changed from 8 characters to 17 characters. The Product ID that is required by the PL522 / PL523 System is the last eight digits. Refer to Item 4 in Illustration 38.Click "OK" after changing each parameter to return to the Configuration screen.To configure a value, highlight the value and select “Change” at the lower left corner of the screen. The current value will appear along with a pull-down menu to select the new value.
Table 17
Parameter Table
Parameter Description Configuration Notes
Machine Serial Number The Machine Serial Number is used by the PL522 / PL523 system for routing and displaying information by machine. For a non-Caterpillar machine, enter the machine serial number. For Caterpillar machines, enter the last eight characters of the new 17 character PIN for this value. Refer to Illustration 38. The maximum length is 17 characters. DO NOT start the serial number with a space. DO NOT abbreviate the serial number. For example, 1AA00123 should not be shortened to 1AA123 DO NOT use uppercase “O” instead of zero “0”. Machine Security (Available in China Only)
Derate - Some machines can have the machine engine derated remotely by the owner