CONDENSER & MOUNTING GP 2W9718 - Caterpillar

Illustration 6 g03589969
Fork Positions for Lifting FPU Cabinet Off Skid- Front View (1) Left Fork Position (2) Right Fork PositionNote: Always lift from the front. Never lift cabinet from sides.Note: Forklift prongs must be no wider than 533.4 mm (21 inch) to lift the FPU Cabinet.
Measure a 533.4 mm (21 inch) gap centered on the FPU cabinet skid to mark where the forks should be placed.
Illustration 7 g03589976
Drawn 533.4 mm (21 inch) Gap to Mark for FPU Cabinet Forklift Placement
Illustration 8 g03589982
Forklift in Position - FPU Cabinet Front/Left Side Angle View
Illustration 9 g03589988
Forklift in Position - FPU Cabinet Left Side Angle View
Draw lines directly on the skid for guidance.Removal of FPU Cabinet Shipping Skid
The cabinet is attached to two shipping skids. The skids provide protection from shock and vibration. The skids are constructed of foam that is sandwiched between two pieces of wood. The skids are attached to the cleats of the cabinets by four bolts.
Illustration 10 g03590005
FPU Cabinet - Bolt Locations (15) Bolts (2 in Front, 2 in Rear)
Illustration 11 g03590010
FPU Cabinet - Bolt Locations (Viewed from Top) (15) Bolts (2 in Front, 2 in Rear)
Remove the four (4) skid bolts that secure the cleats of the cabinets to the shipping skids.
Insert the forks from the forklift into the front of the cabinets. See Figure 8 and Figure 9 for forklift position.Note: Make sure that forks are centered up and line up with lines drawn on the shipping skid.
Tilt forks up slightly and lift the cabinet off the shipping skid.
Remove the shipping skid.Note: Set FPU Cabinet in place and remove the Front Flywheel Module Bracket to install on to the Flywheel Module.Flywheel Module Handling and Unpacking
Illustration 12 g03590022
Fork Positions for Lifting Flywheel Module Off Skid- Front View (16) Left Fork Position (17) Right Fork Position
Illustration 13 g03590029
Fork Positions for Lifting Flywheel Module Off Skid- Front/Right Angle ViewRemoval of Flywheel Module Shipping Skid
Unhook buckles on right and left side.
Illustration 14 g03590031
Flywheel Module - Skid Board Removal (20) Left Buckle (21) Board (22) Right Buckle
Remove front board (21) from skid.Note: Front Flywheel Module Bracket must be removed from the FPU Cabinet.
Illustration 15 g03590035
Bolt Locations - Attach Front Flywheel Module Bracket to the Flywheel Module
Attach Front Flywheel Module Bracket to the Flywheel Module using four bolts (23) located on the bracket.
Insert the forks from the forklift into the front of the cabinets. Refer to Illustration 13 for forklift position.Note: Forklift prongs must be no wider than 533.4 mm (21 inch) to lift the Flywheel Module.
Lift the Flywheel Module off the shipping skid.
Remove the shipping skid.Product Serial Number Locations
Illustration 16 g03656158
Serial Number Locations
The product serial number is located on the inside of the SIO cabinet on the base. (Reference Illustration 16