CONDENSER GP-REFRIGERANT 3787640 - Caterpillar

Illustration 1 g00993157
Typical left-hand side view
Illustration 2 g02261033
View A-A
Illustration 3 g02156574
View B (1) Pad Assembly (2) Shim Thickness ... 2.0 mm (0.08 inch) (3) Plate Thickness ... 8.0 mm (0.32 inch)Note: Refer to the Hydraulic System Systems Operation/Testing and Adjusting, "Pad Assembly (Dump Body) - Install and Adjust" for the proper installation of the pad assemblies.
Illustration 4 g02156583
View C-C (4) Use the 8W-2897 Thrust Washer (4.0 mm (0.16 inch)) and use the 9D-3432 Thrust Washer (6.0 mm (0.24 inch)) to center the body on the frame. Note: Refer to Special Instructions, REHS2594, "Assembly Procedure for the 777F Off-Highway Truck", "Use the 263-3918 Body Mounting to Install the Body".
Illustration 5 g01245193
Detail D (5) Bolts Torque for two bolts ... 13 3 N m (10.0 2.2 lb ft) (6) Body down or up switch (7) Magnet assembly (8) BracketsNote: The body down or up switch will open when the magnet assembly is within a minimum of 11 mm (0.43 inch) from the switch.Note: The body down or up switch will close when the magnet assembly is within a maximum of 8 mm (0.32 inch) from the switch.Note: Before adjusting the body down or up switch (6) , the pad assembly (1) and the shims (2) must be installed. Refer to the Hydraulic System Systems Operation/Testing and Adjusting, "Electronic Control (Body Down or Up Switch) - Adjust" for the proper installation of the body down or up switch.