CONDITIONER GP 1664585 - Caterpillar

Illustration 1 g03600616
Typical example
Table 1
Specification for 440-3352 Final Drive Gp and 440-3353 Final Drive Gp
Item Qty Part Specification Description
1 1 144-8299 O-Ring Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
2 1 442-5378 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
3 1 4D-6695 O-Ring Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
4 18 202-6473 Bolt Torque to 270 40 N m (199 30 lb ft).
5 2 278-3320 Sprocket Assemble sprockets so that the teeth on the sprockets are aligned with each other.
6 12 160-8509 Bolt Torque to 270 40 N m (199 30 lb ft)
7 12 267-8628 Locking Bolt Do not use the four locking bolts in the corners to pull the final drive housing into initial contact with the tandem.
Torque to 270 40 N m (199 30 lb ft).
8 3 103-6169 Self-Locking Bolt Torque to 270 40 N m (199 30 lb ft).
9 As required, use following shims in order to obtain the proper bearing preload:
5 7D-8441 Shim Thickness is 0.13 mm (0.005 inch).
2 9D-7047 Shim Thickness is 0.51 mm (0.020 inch).
5 7D-8439 Shim Thickness is 0.18 mm (0.007 inch).
10 1 8D-3902 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
11 As required, use following shim pack in order to obtain proper end play.
1 264-0196 Shim Pack Total thickness is 1.10 0.25 mm (0.043 0.010 inch).
12 3 8T-0372 Bolt Torque to 105 20 N m (77 15 lb ft).
Illustration 2 g03600656
Typical example
View B-B
Table 2
Item Qty Part Specification Description
- - - The diagonal cut in the rings must be assembled within the points 13 and 14.
C - - Angle for the diagonal cut in the rings is 45 10 degrees.