CONDUIT 2893195 - Caterpillar

Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the proper draining procedure.
Illustration 1 g01308886
Position Tooling (A) under guard (1). The weight of guard (1) is approximately 65 kg (140 lb).
Remove bolts (2). Lower Tooling (A) in order to remove guard (1) from the machine.
Illustration 2 g01308897
Disconnect cable assembly (3) and cut cable straps (4) .
Illustration 3 g01308907
Loosen the clamps around tube assembly (5) in order to remove tube assembly (5) .
Remove clip (6) .
Disconnect cable assembly (7) and disconnect harness assembly (8) .
Illustration 4 g01308937
Loosen the hose clamps around elbow (9) in order to remove elbow (9) .
Disconnect hose assemblies (10) .
Illustration 5 g01308939
Remove pin (11) .
Repeat Step 10 for the opposite side of the machine.
Illustration 6 g01308954
Remove bolts (12) in order to remove support assembly (13) .
Repeat Step 12 for the opposite side of the machine.
Loosen the clamps around tube assembly (14) in order to remove tube assembly (14) .
Illustration 7 g01309163
Loosen the clamps around tube assembly (15) in order to remove tube assembly (15) .
Attach Tooling (B) and a suitable lifting device to cooling system package (16) .
Illustration 8 g01309172
Remove bolts (17) and (18) .
Repeat Step 17 for the opposite side of the machine.
Illustration 9 g01309189
Remove bolts (19) .
Repeat Step 19 for the opposite side of the machine.
Illustration 10 g01309203
Use Tooling (B) and the suitable lifting device in order to carefully remove cooling system package (16) from the machine. The weight of cooling system package (16) is approximately 499 kg (1100 lb).